Oven Vent; Baking; Outdoor Grill And Oven Care; Replacing The Igniter Battery - JENN-AIR 720-0727 Instrucciones De Instalación Y Manual De Uso Y Cuidado

Oven Vent

A
The oven vent is located on the oven back panel. The oven vent
releases hot air and moisture from the oven, and should not be
blocked or covered. Blocking or covering the oven vent will cause
poor air circulation, affecting cooking and cleaning results. Do not
set plastics, paper or other items that could melt or burn near the
oven vent.

Replacing the Igniter Battery

If igniters stop sparking, the battery should be replaced.
1. Open battery box cover on front of control p a nel.
2. Unscrew igniter cap counterclockwise to remove.
A. "AA" size battery
B. Igniter cap
3. Remove battery from the battery compartment.
4. Replace with a new alkaline "AA" size battery. Install battery
with negative end in first.
5. Screw igniter cap clockwise into place.
6. If necessary, repeat steps 1-5 for the other battery.
A. Oven vent

OUTDOOR GRILL AND OVEN CARE

A
B
Before baking, position the racks according to the "Positioning
Racks and Bakeware" section.
To Bake:
1. Push in and turn the oven control knob to the desired
temperature setting. The oven indicator light will turn on and
remain on until the oven reaches the set temperature.
2. Place food in oven. The burner will turn on and off to maintain
cooking temperat u re. The oven indicator light will turn on and
off with the burner.
3. Turn oven control knob to OFF when finished.

Changing the Grill Light Bulb

1. Unplug grill or disconnect power.
2. Make sure the light power switch on the control panel is in the
OFF position.
3. Use a Phillips screwdriver to remove the four screws securing
the light cover to the grill hood.
B
A
A. Remove these screws
B. Light cover
NOTE: When removing final screw from the light cover, make
sure to hold the cover in place, ensuring it doesn't fall and
shatter.

Baking

A
33