JENN-AIR 720-0727 Instrucciones De Instalación Y Manual De Uso Y Cuidado página 18

2. Using a Phillips screwdriver, remove the 6 screws at the back
of grill from inside the grill.
3. Remove the access cover at the back of the grill hood by
removing the 6 screws.
A
A. Access cove r
4. Using a Phillips screwdriver, remove the 1 screw holding the
spider guard to the burner.
18
5. Use 24 mm wrench to remove the orifice nut.
A. Orifice nut
6. Take out the orifice support, and then use a 6 mm socket and
wrench or 6 mm nut dr i ver to remove the LP orifice at the end
of the supply pipe. Replace with Natural gas orifice.
A
B
A. Orifice support
B. Orifice
IMPORTANT: Check that the orifice is properly installed inside
of the supply pipe.
7. Reinstall the orifice support and supply pipe and tighten the
nut with a 24 mm wrench.
8. Reinstall the spider guard, access cover, and wind baffle.
Ch ange the Sear Burner Orifices
1. Remove the screw securing the igniter and the 2 sear burner
screws.
A