Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Digital Multimeter/ English
OvervoltageCategory III
Equipment of OvervoltageCategory III is equipment in fixed installations.
Note: Examples include switches in the fixed installation and some equipment for
industrial use with permanent connection to the fixed installation.
OvervoltageCategory IV
Equipment of OvervoltageCategory IV is for use at the origin of the installation.
Note: Examples include electricity meters and primary over-current protection equipment
4.Safety Instructions
This meter has been designed for safe use, but must be operated with caution. The rules
listed below must be carefully followed for safe operation.
• Never apply voltage or current to the meter that exceeds the specified maximum:
Input Protection Limits
Function
Maximum Input
V DC or V AC
1000VDC AC rms
mA AC DC
800mA 1000V fast acting fuse
10A 1000V fast acting fuse (20A for 30 seconds
A AC DC
max every 15 minutes)
Frequency, Resistance, Capacitance,
1000VDC AC rms
Duty Cycle, Diode Test, Continuity
Temperature
1000VDC AC rms
• Use Extreme Caution when working with high voltages.
• Do Not measure voltage if the voltage on the "COM" input jack exceeds 1000V above
earth ground.
• Never connect the meter leads across a voltage source while the function switch is in
the current, resistance, or diode mode. Doing so can damage the meter.
• Always discharge filter capacitors in power supplies and disconnect the power when
making resistance or diode tests.
• Always turn off the power and disconnect the test leads before opening the covers to
replace the fuse or batteries.
• Never operate the meter unless the back cover, battery and fuse covers are in place and
fastened securely.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
2
5.Controls and Jacks
1. 6,000 count LCD display
2. Hz% button
3. RANGE button
4. MODE button
5. Function switch
6. mA, μA and 10A input jacks
7. COM input jack
8. Positive input jack
9. Backlight and Hold button
10. MAX/MIN button
11. REL button
Note: Tilt stand and battery compartment are on
rear of unit.
6.Symbols and Annunciators
AUTO
13/12/2017 Version No. 001
13/12/2017 Version No. 001
•)))
Continuity
Diode test
Battery status
-9
n
nano (10
) (capacitance)
-6
μ
micro (10
) (amps, cap)
m
-3
milli (10
) (volts, amps)
A
Amps
3
k
kilo (10
) (ohms)
F
Farads (capacitance)
6
M
mega (10
) (ohms)
Ω
Ohms
Hz
Hertz (frequency)
V
Volts
REL
Relative
AC
Alternating current
Autoranging
Digital Multimeter/ English
S1
1
P3
P2
P1
BP60
BP0
BP1
S2
3
11
2
MAX
Hz%
RANGE
REL
MIN
10
4
9
MODE
5
8
10A
6
7
MAX 600mA
S1
P3
P2
P1
BP60
BP0
BP1
S2
DC
Direct current
HOLD
Display hold
o
F
Degrees Fahrenheit
o
C
Degrees Centigrade
MAX
Maximum
MIN
Minimum
AUTO
Auto Range
Timing symbol
Backlight
bargraph
3
Tabla de contenido
