Proper Disposal Of Your Refrigerator; Before You Throw Away Your Old Refrigerator Or Freezer; Cutout Dimensions; Installation Instructions - Amana BB20VE Manual Del Propietário

!
Proper Disposal of your
Refrigerator
IMPORTANT: Child entrapment and suffocation are not
problems of the past. Junked or abandoned
refrigerators are still dangerous—even if they sit for
"just a few days". If you are getting rid of your old
refrigerator, please follow the instructions below to help
prevent accidents.
BEFORE YOU THROW AWAY YOUR OLD
REFRIGERATOR OR FREEZER:
• Take off the doors.
• Leave the shelves in place so children may not
easily climb inside.

Cutout Dimensions

Single Installation
H • 69" with 12" deep cabinets above refrigerator.
• 70" with 24" deep cabinets above refrigerator.
W 36"
D 24"

Installation Instructions

Proper installation will ensure that this refrigerator
operates most efficiently. Amana cannot be responsible
for improper installation.
Tools Required
5 / " hex nut driver
16
3
/ " hex nut driver
8
1
/ " hex nut driver
4
Putty knife (blade covered by masking tape)
DANGER
Phillips screwdriver
Blade screwdriver

IMPORTANT:

• Save all screws for reuse.
• For plug removal requiring use of flat blade screwdriver
or putty knife, blade of tool must be covered with
masking tape to avoid damage to refrigerator
finish. For plugs using a screwdriver or nut driver style
head, use appropriate tool to avoid damage to plugs.
!
To avoid personal injury or property damage caused by
refrigerator tipping, stabilizing leg must be firmly
against floor.
Door Reversal (Contour door model)
Only a qualified servicer can reverse this door. To have
doors reversed, please call 1-800-843-0304. There is a
fee charged for this service.
Door Reversal (Front mounted handle)
Some installations may require door reversal to achieve
full door swing. To reverse door swing direction perform
the following steps.
1. Remove refrigerator
• Remove handle screw from top handle trim. Pry up
edge of handle trim using a putty knife with the
blade covered with masking tape. Remove handle
from door by removing 1 remaining mounting
screw at each end of handle.
• Remove 1 plug from top hinge side of door and 2
from front hinge side of door. Transfer plugs to
opposite side of door to fill empty mounting holes.
C
C
A
A
A Handle trim
B Handle
2. Remove freezer door
• Open freezer door 90°. Locate two notches on
back of freezer handle. Insert flat screwdriver
blade or putty knife blade wrapped in masking
tape. Pry up back edge of handle cap and remove
from handle.
• Remove handle from door by removing two
mounting screws.
• Remove 2 plugs from hinge side of freezer door
and transfer to opposite side to fill holes left from
handle removal.
A
A Handle
B Handle cap
3
CAUTION
handle:
A
A
B
D
C Screws
D Plugs
handle:
B
C
D
C Screws
D Plug