Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TECHNICAL AND HEATING SPECIFICATIONS
Hopper capacity
Efficiency
Power output
Autonomy min/max
Flue consumption min/max
Heating capacity *
Weight including packaging min/max
Smoke duct diameter (A female)
Air inlet duct diameter (B male)
* The heatable room dimensions are calculated on the basis of
pellets with an lhv of at least 4300 kcal/kg and home insulation in
compliance with Italian law 10/91, and subsequent changes toge-
ther with an expected heat output of 35 Kcal/m³ per hour.
* It is also important to consider the position of the stove in the
room to be heated.
N.B.
1) bear in mind that external devices may cause interference.
2) caution: live parts. Servicing and/or inspections must be carried out by qualified staff.
(Before carrying out any maintenance, disconnect the device from the mains power supply)
ELECTRICAL CHARACTERISTICS
Power supply
On/off switch
Average power consumption
Power consumption during ignition
Remote control frequency (optional)
Protection on mains power supply **
Protection on electronic circuit board
SAFETY DEVICES:
THERMOCOUPLE:
placed at the smoke outlet to detect the temperature.
Turns the stove on and off and controls its operation based on
defined parameters.
AIR FLOW SENSOR:
installed at the intake duct, it trips when the combustion air fl ow is
not correct, causing low pressure problems in the smoke circuit.
SAFETY THERMOSTAT:
trips when the temperature inside the stove is too high.
It stops pellet loading, causing the stove to shut down.
FUSE
**two fuses are inserted on the socket
behind the stove, fitted with a switch one
is functional and the other is spare.
* *
20
kg
85
%
9,3
kW
9/18
hours
1,1/2,2
kg/h
260
m
3
141/186
kg
80
mm
40
mm
230Vac +/- 10% 50 Hz
Yes
150
W
400
W
Infrared
2A, 250 Vac Fuse 5x20
2A, 250 Vac Fuse 5x20
- 16
-
SMOKE RPM
backup
battery
SMOKE EXTRA-
TION MOTOR
FEED
SCREW
MOTOR
VENTILATION
Connessioni cavo combinatore telefonico
SERIAL PORT
The Dealer can install an optional
on the AUX outlet (clean contact
on the pins) for controlling the
process of switching on and off
Pin 6 e pin 7
(e.g. telephone remote, local thermostat), located at the
620550
rear oh the stove. Can be connected via special optional
trestle (code 621240).
BACKUP BATTERY
A backup battery is found on the control board (3-Volt
CR 2032 battery). Its malfunction is indicated with the
following messages: (not considered a defect but due
to normal wear-and-tear): ERROR RTC CD. For more
detailed information, please contact the DEALER who
has performed the first 1st ignition.
FLOW
SENSOR
ROOM
TEMPERATURE
SENSOR
230 VAC PO-
WER SUPPLY
IGNITION RESISTANCE
pin 2
pin 6
Pin 2 e pin 6
621240
Tabla de contenido
