Mountng Wheels; Workstand Set-Up; Before You Start - RIDGID AC9940 Manual Del Usaurio

Assembly (continued)

Mountng Wheels

1. Slide axle bolt outwards until it extends
beyond the frame.
2. Remove axle nut.
WARNING: Do not remove axle
bolt(s) from the frame. Energy
from gas spring can cause injury
if leg is disconnected from axle
bolt(s).
3. Place washer and wheel on axle bolt as
shown.
4. Replace axle nut and washers as
shown. Tighten nuts securely. Check to
see that the wheel freely spins. If not,
slightly loosen axle nut.
5. Repeat steps 1-4 for opposite wheel.
6. Press plastic cap over each wheel nut
by gently tapping with a hammer.

Workstand Set-up

Before you start:

• If a miter saw is already assembled to
the stand, make sure that it is securely
attached to the stand per the instructions
in this manual.
• If a miter saw is already assembled to
the stand, make sure to place the blade
90° to the table (if applicable), miter the
blade to the right as far as it will go,
place the blade in the "locked down"
position, and lock all knobs and levers.
Outwards
6
Upright Position