Worksite Preparation; Acceptable Base Materials; Inappropriate Base Materials; Check Before Fastening - Nitroset NTS8X Manual Del Usuario

Worksite Preparation

Acceptable Base Materials

The NITROSET® tool is for fastening into the following base materials only:
Concrete
Structural Steel
Never attempt to fasten into any material other than those listed above.

Inappropriate Base Materials

The NITROSET® tool is NOT for fastening into the following base materials:
Wood
Drywall
Glass
Tile
Rock
These materials may shatter causing the fastener or base substrate to
fly free and may cause serious injury to the operator or bystanders.

Check Before Fastening

Check the thickness and type of base material before fastening. Follow your
specific jobsite instructions and building code requirements.
Minimum concrete thickness is three times the fastener penetration
(ie. 3" of concrete base material is a minimum requirement for 1"
penetration).
In fastening into steel substrate, the minimum thickness of substrate must
be 3/16".
W W W . N I T R O S E T . C O M
5