Tool Disassembly - Nitroset NTS8X Manual Del Usuario

Tool Disassembly

14
Remove Debris Cup from the Muzzle.
Remove Muzzle from the Reset Sleeve.
Use the included wrenches for
assistance as necessary.
Slide the Adapter off the threads of the
Muzzle as necessary.
Remove the End Cap from the tool.
Slide the Firing Spring off the tool. Note
the Buffer is attached to the end of the
Firing Spring. Check condition of Firing
Spring and Buffer.
Slide off the Outer Cover Sleeve.
Depress the Reset Spring to collapse
1
the Reset Sleeve. This will loosen the
Main Assembly Pin and allow it to be
1
2 removed from the tool.
Slide the Main Firing Assembly from
the main body of the tool.
2
Depress the Trigger Ball Release to
compress the Trigger Ball Spring and
slide the Firing Pin Assembly from the
Firing Pin Guide.
2
Keep pressure over the Trigger Ball to
hold it in place while removing the
1
assembly. Releasing the Trigger Ball
may cause it to spring up.
Once the Firing Pin Assembly has been
removed from the Guide, slowly
release the Trigger Ball and remove it
from the Firing Pin Holder.
To remove the Firing Pin, use the
provided firing pin punch and knock
out the 1/8" Roll Pin.
W W W . N I T R O S E T . C O M