Charging - Silvercrest SAS 7.4 LI C1 Instrucciones De Uso

2) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter
3) Drill two holes about 34 mm apart. Use the wall bracket
to ensure the correct spacing. The drill holes must be suitable for 5 mm wall
plugs.
4) Push the wall plugs into the holes and then screw the wall bracket
into place using the screws.
5) You can place the nozzles on the accessories holder on the side.
6) Connect the mains adapter

Charging

NOTE
► Ensure that the on/off switch
ance is switched off) before starting the charging process.
■ Place the handheld vacuum cleaner from above into the wall bracket
that the barrel plug
The charge indicator lamp
■ When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function). The charge indicator lamp
Nevertheless, in order to avoid possible damage to the batteries, do not
leave the appliance permanently connected to the mains adapter
■ Do not recharge the batteries again until the handheld vacuum cleaner's
suction power becomes appreciably weaker and the charge indicator lamp
flashes green.
NOTE
► If the handheld vacuum cleaner is deep-discharged, the charge indicator
lamp
switch off the appliance and start charging.
► The handheld vacuum cleaner can also be charged directly via the mains
adapter
the wall bracket
cleaner.
■ 50 │ GB │ MT
slips into the socket on the handheld vacuum cleaner.
lights up red and the charging process begins.
flashes alternately red and green (approx. 1 minute). In this case,
. To do this, remove the barrel plug
and insert it into the socket on the handheld vacuum
to a mains power socket.
has been pushed back (and thus the appli-
with a slight twist from
:
.
to mark the holes,
firmly
so
lights up green.
.
SAS 7.4 LI C1