Installation Of The Wall Bracket; Charging - Silvercrest SAS 7.4 LI D3 Instrucciones De Uso

Installation of the wall bracket

DANGER – ELECTRIC SHOCK!
►
Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket
Drilling into a current-carrying electric cable can be potentially fatal!
1) Insert the barrel plug
shown in the following diagram:
First, feed the cable through the cable routing and then push the barrel plug
into the opening in the wall bracket
barrel plug
2) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter
3) Drill two holes about 60 mm apart . Use the wall bracket
holes, to ensure the correct spacing . The drill holes must be suitable for 6 mm
wall plugs .
4) Push the wall plugs into the holes and then screw the wall bracket
into place using the screws .
5) You can place the nozzles on the accessories holder on the side .
6) Connect the mains adapter

Charging

NOTE
► Check to ensure that the on/off switch
position "0") before starting the charging process .
■ Place the handheld vacuum cleaner from above into the wall bracket
that the barrel plug
The charge indicator lamp
SAS 7.4 LI D3
on the mains adapter
5
by turning it .
5
to a mains power socket .
4
slips into the socket on the handheld vacuum cleaner .
5
lights up red and the charging process begins .
7
into the wall bracket
4
so that it is firmly in place . Secure the
3
3
3
has been pushed back (to the
6
GB │ MT
.
3
as
3
5
:
.
4
to mark the
firmly
3
so
3
│ 57 ■