M-Pwr ™ 40V Battery & Charger - Hoover HushTone CH34006 Manual Del Usuario

M-PWR 40V Battery & Charger (Sold Separately)
™
NOTE: Batteries are shipped in a low charge condition to prevent possible problems. You should
charge them before first use.
Only one battery is charged at a time. When two batteries are in place, the battery with the most
power remaining will be charged first. This ensures the fastest time to full charge.
CHARGING AMBIENT TEMPERATURE RANGE: 5 °C – 50 °C (41 °F – 122 °F)
1
To charge the battery, slide
battery into charger. Push
backward until battery clicks into
place and LED Status Indicator
is lit.
66%–100% Charged
33%–66% Charged
10%–33% Charged
0%–10% Charged
3
When charging, the fully lit LEDs
on the battery will indicate charge
level.
12
2
Charger LED Status Indicator will
turn green when battery is fully
charged.
If the charger flashes red, an error
has occurred. Remove and replace
battery.
4
To remove battery, press the
release button and slide battery
forward while holding down on
charger base.
1
Insert battery into housing by
grasping the integrated handle
and pushing firmly in until battery
locks into place.
3
Press orange switch to power up
the unit.
ON: Hush mode quiet cleaning
™
BOOST: High traffic area cleaning
Turn off by returning switch to
center position.
66%–100% Charged
33%–66% Charged
10%–33% Charged
0%–10% Charged
2
Verify power level of the battery
with LEDs on the power switch
housing.
4
To remove battery, grasp the
integrated handle while pressing
the release button. Slide out from
housing by pulling while holding
down release button.
13