Tabla de contenido
3.9 Installing Wire Rolls
To select the appropriate wire refer to Section 4.3 for guidance.
1.
Open the le
2.
Remove the Thumbscrew Spool Lock
3.
Remove the Spring and the Spool Retainer
4
.
Place the Welding Wire Spool on the Spindle.
5.
Load the wire as shown in the diagram on the following page.
6.
Once the wire is in the feed position, close the side panel and turn on the
welder.
7.
Use the MIG gun trigger to advance the wire through the torch until it
reaches a 1/4 to 3/8 stickout (electrode extending from the tip of the contact
tube.). (See Diagram 1 on the following page)
ft side panel (when facing the front of the welder)
3‐7
Tabla de contenido
Solución de problemas
