Replacing The Oven Lamp - Brandt BXE5532X Manual De Utilización

+ and - .
The cooking end time is automatically saved after a
few seconds. The cooking end time display stops
flashing.
5
CLEANING THE OUTER SURFACES
Use a window washing product applied to a soft
cloth. Do not use abrasive creams or scouring
sponges.
CLEANING INSIDE THE OVEN
Clean the still-warm oven with a cloth dipped in hot,
soapy water and wipe with a lint-free cloth.
5.1
REMOVING THE SHELF SUPPORTS AND
REPLACING THE CATALYTIC SIDE PANELS
Side panels with wire shelf supports :
Lift the front part of the wire shelf support
upwards. Press the entire shelf support and
release the front hook from its housing. Then
gently pull the whole of the support towards you
to release the rear hooks from their housing.
Remove the two shelf supports and the catalytic
side panels. Re-install the new elements
(side panels) following the procedure in
reverse.
5.2
CLEANING THE INSIDE GLASS
To clean the inside glass, remove the door. Before
doing this, remove any excess grease with a soft
cloth and washing up liquid.
Warning
Do not use scouring cleaning products,
abrasive sponges or metal scrapers to clean
the oven's class door, which may scratch the
surface and lead to the glass breaking.
REMOVAL
Open the door fully and block it with the plastic
wedge provided in your appliance's plastic pouch.
Remove the first clipped glass panel:
Use a tool (screwdriver) to press the slots A in order
to unclip the glass panel.
Remove the glass panel.
Depending on the model, the door consists of two
additional glass panels, with a black rubber spacer
at each corner. If necessary, remove them to clean.
Do not soak the glass panels in water. Rinse with
clean water and dry off with a lint-free cloth.
RE-ASSEMBLING THE DOOR
After cleaning, reposition the four rubber stops with
Cleaning
the arrow upwards.
Reposition all of the glass panels.
Slip the last glass panel into the metal stops, then
clip it in with the shiny side facing outwards.
Remove the plastic wedge.
Your appliance is now ready for use again.
5.3
Warning:
Make sure the appliance is disconnected
from the power before replacing the lamp
in order to avoid the risk of electric
shock. Change the lamp only when the
appliance has cooled down.
Bulb specification:
15 W, 220-240 V~, 300°C, E14 cap.
To unscrew the view port and the light, use a
rubber glove, which will make disassembly easier.
6
6.1
Press
tings.
Activate or de-activate the different parameters
with + and -; see table below:
To exit the "MENU", press

REPLACING THE OVEN LAMP

MENU
You can adjust different
settings on your oven. To
do so:
Press
+
the "MENU" display to
access the settings mode.
again to scroll through the different set-
Activate/de-activate the
beeping sound of the
buttons
Activate/de-activate
demonstration mode
again.
ENGLISH
Settings
until you get to