Kenmore 795.5183 Manual De Uso Y Cuidado página 16

USING YOUR REFRIGERATOR
Accela Ice
• When you press and hold the Ice Maker button for
approximately three seconds, the Accela Ice icon on the
display panel will illuminate and will continue for 24
hours.
• You can stop this function manually by pressing and
holding the Ice Maker button for three seconds or
more.
• This function increases both ice making and freezing
capabilities.
Water Filter Reset
lter indicator turns on, you need
lter, press and hold the Filter Reset button for three
months.
Door Alarm
• When power is connected to the refrigerator, the door
alarm is activated. This function cannot be deactivated.
• When either the refrigerator or the freezer door is left
open for more than 60 seconds, the alarm tone will
sound to let you know that the door is open.
• When you close the door, the door alarm will stop.
Control Lock
• The Control Lock button deactivates the controls and
dispenser functions. When power is initially connected
to the refrigerator, the Lock
• If you want to activate the Lock function to lock other
buttons, press and hold the Control Lock button for
three seconds or more. The Control Lock indicator will
turn on and the Lock function is now enabled.
• When the Lock function is activated, no other buttons
will work. The dispenser pad is also deactivated.
• To disable the Lock function, press and hold the Control
Lock button for approximately three seconds.
A white light illuminates the dispenser area whenever
the dispenser pad is engaged. The dispenser area
can also be illuminated by a mood light, which is
activated by pressing the Light button. When the
Mood Light is activated, the indicator light above the
Light button turns on.
after 24
lter. After changing the water
. You need
lter approximately every six
.
CAUTION
Demo Mode (For Store Use Only)
The Demo Mode disables all cooling in the
refrigerator and freezer sections to conserve energy
while on display in a retail store.
To deactivate:
With either refrigerator door opened, press and
hold the Refrigerator Temp. and Accela Ice buttons
will beep and the temperature settings will display
rm that Demo Mode is deactivated. Use the
same procedure to activate the Demo Mode.
Adjusting Control Settings
Give the refrigerator time to cool down completely
24 hours to let the normal settings (recommended
in the Temperature section) stabilize before making
any changes. If you need to adjust the temperature
in the refrigerator or freezer, start by adjusting the
refrigerator temperature and allow 24 hours for the
temperature to stabilize again. If it is still too warm or
too cold, then adjust the freezer control.
Use the settings listed in the chart below as a guide.
Always remember to wait at least 24 hours between
adjustments.
CONDITION/REASON
REFRIGERATOR section too
warm.
• Door opened often.
• Large amount of food
added.
• Room temperature very warm.
FREEZER section too warm/ice
not made fast enough.
• Door opened often.
• Large amount of food added.
• Very cold (55°F (13°C)) room
temperature. (Compressor
does not cycle often enough.)
• Heavy ice usage.
• Air vents blocked by items.
REFRIGERATOR section too
cold.
• Controls not set correctly for
your conditions.
FREEZER section too cold.
• Controls not set correctly for
your conditions.
16
ve seconds. The control panel
nal adjustments. It is best to wait
RECOMMENDED ADJUSTMENT
• Set the REFRIGERATOR
control one degree
colder; wait 24 hours for
the new setting to take
ect before making
another adjustment.
• Set the FREEZER control
one degree colder;
wait 24 hours for the
new setting to take full
ect before making
another adjustment.
• Move items out of air
stream.
• Set the REFRIGERATOR
control one degree
warmer; wait 24 hours for
the new setting to take
ect before making
another adjustment.
• Set the FREEZER control
one degree warmer;
wait 24 hours for the
new setting to take full
ect before making
another adjustment.