Pentair SFE Manual Del Usuario página 33

S F E
DATA
E
N
G
L
I
S
H
Press to switch parameters.
While the parameters are being edited, the regeneration icon is on and flashing.
DESCRIPTION
Duration of the third regeneration cycle stop (minutes). Press
or to edit. If the parameter is set to off, the stop will
be skipped and the system will directly go to the next stop.
Duration of the fourth regeneration cycle stop (minutes). Press
or to edit. If the parameter is set to off, the stop will
be skipped and the system will directly go to the next stop.
Number of regenerations before a salt alarm is generated. Press
or to edit.
NOTE: See note 1 to calculate the number of regenerations
before a salt alarm is generated.
Days of interval for the mandatory regeneration. Press
or to edit. If this parameter is set to Of, the function is
disabled.
NOTE: This type of regeneration is carried out at the
regeneration time even on non enabled days.
Frequency of the mains 50 or 60 Hz. Press
Duration of the cycle end pulse, this parameter can take values
from 1 to 99 minutes. Press or to edit .(only with 7930-23
board)
Chlorine driver activated (only with 7930-24 board)
UdIF  Volume not restored
UIMM  Volume restored
Confirm with . The volume remaining will be kept in
memory or restored to the programmed value, after exiting the
programming. (SH 1 or SH 2)
End of the programming
DEFAULT
5
5
10
14
50
or to edit.
FC01
FCCL
UdIF
N.A.
32
MIN - MAX
Of-99
Of-99
00-99
Of-14
50-60
01-99
N.A.
N.A.
N.A.