Playcore Swing-N-Slide 7 Instrucciones De Ensamblaje página 9

Fig. 4
1" from top of deck
Fig. 5 Pre-Drill
Mounting PanEl
1. Position the mounting panel as indicated in (Fig.
4) (The stamped "T" should be at the top). The
panel should be placed to the opening so all the
bolt holes fully expose a wood surface except
those identified with arrows (which should be
clear of any wood surface). The bottom of the
opening should be approximately 1" below the
deck surface.
2. Hold the panel in position and mark all hole
locations. Remove panel.
3. Drill a 3/8" hole through the top support at the
locations indicated in (Fig. 5) (two holes are
required).
4. Drill pilot holes at the remaining hole locations
using a 1/8" drill bit. notE: The pilot holes at
each corner hole location should be approximately
2" deep. The remaining pilot holes should only
be 1" deep.
5. Align the mounting panel to the previously
assembled entrance section (see Fig. 1,
page 7). Attach the mounting panel to the
entrance section at the hole locations indicated in
(Fig. 4) using one 1" bolt, two washers and one
loc nut per hole as indicated in (Fig. 6).
notE: Hand tighten the loc nuts only.
1'' bolt
washer
Fig. 6
9
ssembly Instructions
washer
loc nut