Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ssembly Instructions
Fig. 1
Entrance Section - 14 bolts
Fig. 2
Exit Section - 13 bolts
flanged lip
flat lip
t
90˚ Section (2 are required) - 13 bolts each
8
EntrancE SEction, 90° SEction (2)
and Exit SEction
notES:
• At least two individuals are needed to
assemble the Turbo Tube Slide.
• To aid in aligning holes when assembling
sections, insert a screwdriver through adjacent
holes to maintain hole alignment.
1.
Identify each slide section as either (1), (2),
(3), (4), (5), or (6) as marked on the lip of each
piece.
2.
Assemble entrance section using pieces (1) &
(2), two 90° sections using pieces (3) & (4),
and the exit section using pieces (3) & (5).
Join sections using a 3/4" hex head bolt, two
flat washers, and a loc nut at each hole
junction (Fig. 1, 2 & 3). notE: Fasten each
loc nut finger tight until the entire slide is
assembled. Each time you join parts be sure
each flanged lip is mating with a flat lip.
3/4" bolt
washer
washer
loc nut
Fig. 3
Tabla de contenido
