Playcore Swing-N-Slide 7 Instrucciones De Ensamblaje página 12

ssembly Instructions
Fig. 11
2-3/4" bolt
2-3/4" bolt
washer
3"
washer
washer
washer
loc nut
washer
2-1/2" lag bolt
1-1/2" lag bolt
Fig. 12
Mounting SlidE
1. The help of at least one other individual
will be required for mounting the slide.
2. Insert the 2-3/4" bolts through a washer,
through previously drilled 3/8" holes in the
upper rail of the unit (see Fig. 11).
3. Carefully lift the slide assembly to the
opening of the unit. Place the mounting
panel/slide assembly on the 2-3/4" bolts
previously inserted (see Fig. 11). Place
washers and loc nuts on the bolts and
hand tighten.
4. Adjust the mounting panel/slide assembly
loc nut
until the holes of the mounting panel align
with the previously drilled pilot holes.
5. Attach the top corners of the mounting
panel/slide assembly first using a 2-1/2"
lag bolt and washer . Secure the
remainder of the panel/slide assembly to
the unit using 1-1/2" lag bolts and
washers at each open hole location (8 are
required).
6. Tighten the 2-3/4" bolts securely.
7. Attach the bottom corners of the mounting
panel/slide assembly using a 2-1/2" lag
bolt and washer.
SlidE baSE
1. Remove approximately 3" of grade
directly beneath the base of the slide.
12