Playcore Swing-N-Slide 7 Instrucciones De Ensamblaje página 11

Fig. 9
Rotate seam two
holes to the left
(counterclockwise)
tubE aSSEMbly (cont.)
5. Position the exit section to the previously
attached sections so the seams line up.
Rotate the section two holes to the left
(counterclockwise) and realign with the
holes of the entrance section (see Fig.
9).
6. Insert a 3/4" bolt through a washer,
through the slide sections, a second
washer and secure with a loc nut.
notE: Hand tighten the loc nuts only at
this time.
7. Position the slide base to the slide
assembly as indicated in (Fig. 10).
8. Insert a 3/4" bolt through a washer,
through the slide sections, a second
washer and secure with a loc nut.
9. Tighten all of the bolts of the slide
sections securely at this time.
notE: Do not tighten the bolts of the
mounting plate at this time.
hole
dimple
11
ssembly Instructions
Fig. 10
dimple