Pioneer VREC-100CH Manual De Usuario página 7

Precautions before connecting the system
CAUTION
•Firmly install this product so it does not fall off the window. If this product is not
firmly installed, it may fall off the window while driving and cause an accident.
Periodically inspect this product.
• Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to
remain exposed.
• It is extremely dangerous to allow cables to become wound around the steering
column or gearstick. Be sure to install this product, its cables, and wiring away in such
so that they will not obstruct or hinder driving.
• Make sure that the cables and wires will not interfere with or become caught in any of
the vehicle's moving parts, especially the steering wheel, gearstic handbrake, sliding
seat tracks, doors, or any of the vehicles controls.
• Do not route wires where they will be exposed to high temperatures. If the insulation
heats up, wires may become damaged, resulting in a short circuit or malfunction and
permanent damage to the product.
• Do not shorten any cables. If you do, the protection circuit (fuse holder, fuser or filter,
etc )may fail to work properly.
• Never feed power to other electronic products by cutting the insulation of the power
supply cable of this product and tapping into the cable. The current capacity of the cable
will be exceeded, causing overheating.
To prevent damage
WARNING
When replacing the fuse, be sure to only use a fuse of the rating prescribed on this
product.
Precautions before installation
CAUTION
Never install this product in places where, or in a manner that:
6 / 22