Error Messages And Diagnostics - Pilz PSEN op2H Instrucciones De Uso

PSEN op2H Series

7.2. Error messages and diagnostics

The LEDs that display the function can also be used to show operators
the main causes of a device failure or defect.
RECEIVER:
Fault
Check the output connections.
- If a capacitive load > 0.1µF is generated, contact PILZ
customer services.
- Hold the TEST button down for at least 0.5 s (see Ch. 6
"Timing diagram for the RESET function").
If the fault continues, contact PILZ customer services.
- Hold the TEST button down for at least 0.5 s (see Ch. 6
"Timing diagram for the RESET function").
If the fault continues, contact PILZ customer services.
- Check the alignment of both devices.
- Hold the TEST button down for at least 0.5 s (see Ch. 6
"Timing diagram for the RESET function").
If the fault continues, contact PILZ customer services.
- Switch the device off and then on again; ensure that the TEST
input is connected to the supply voltage via a button via a N/C
contact.
- Power supply failure. Check the connections, check that the
supply voltage value is correct.
Transmitter:
Fault
- Transmitter is not working. Check the connections, check that
the supply voltage value is correct.
- If the fault continues, contact PILZ customer services.
- Power supply failure. Check the connections, check that
the supply voltage value is correct.
Instruction Manual
Checks/remedy
Checks/ remedy
28