Technical Data; Special Safety Instructions - Probuilder 31123 Manual De Instrucciones

CIRCULAR BENCH SAW
Introduction
To get the most out of your new circular
bench saw, please read this manual and
the enclosed safety instructions before use.
Please also save the instructions in case you
need to refer to them at a later date.

Technical data

Voltage/frequency:
Power rating:
Speed:
Saw blade:
Sawing depth at 90/45°:
Saw bench:
Sound pressure, L :
pA
Sound level, L : Sound level, L Sound level, L
WA WA
230 V ~ 50 Hz
1,200 W
4,800 rpm
Ø210×2.6 mm
Hole diameter 30 mm
20 teeth
45/41 mm
513×400 mm
93.2 dB(A)
106.2 dB(A)
KPA: 3 dB(A)

Special safety instructions

Do not use for cutting posts or logs.
Never stop the saw blade by pressing against
the saw, or by applying pressure to the side
of the saw blade.
Never use saw blades made of high-speed
steel.
Never use grinding or cutting blades.
Always use the correct type of saw blade for
the job at hand.
Never use saw blades whose maximum
speed is less than the tool's maximum RPM.
Never use bent saw blades or saw blades that
have teeth missing.
Never use saw blades that are too big.
Never use a saw blade thicker than the
cleaver blade.
Personal protective equipment:
Use safety goggles and hearing and
breathing protection.
We recommend � tting extraction to reduce
the level of noise in the room.
Always wear protective gloves when
handling the blade. Never place your hand
in the vicinity of the saw blade and never
attempt to remove materials from the work
area whilst the saw blade is spinning.
Use a push stick or block to push the item
towards the blade if the distance between
blade and guide is less than 12 cm.
Never lock the protective guard in its open
position except when changing blades as
described below.
GB
27