Cleaning And Maintenance; Service Centre - Probuilder 31123 Manual De Instrucciones

Replacing the saw blade (� g. 14-15)
Remove the cover (21) from the side of the
bench saw by removing the four screws.
Hold the shaft (22) securely using a spanner
and loosen the locking screw on the shaft
using the spanner (23) to turn it in the
direction of rotation of the saw blade.
Remove the blade.
Place a new blade on the shaft and screw it
tight.
Check that the direction indicated on the saw
blade matches the direction of rotation of
the motor.
Tighten the lock screw carefully.
Replace the cover.
Switch the saw on and allow it to run freely
for one minute to check that it is functioning
correctly.
Adjusting the cleaver blade (� g. 16-18)
The cleaver blade must always be re-adjusted
if the saw blade has been replaced.
Remove the blade guard.
Remove the 8 screws holding the bench inlay
in place and lift the bench inlay out.
Loosen the 2 screws holding the cleaver
blade in place.
Adjust the cleaver blade so that the distance
between it and the saw blade is 3-5 mm,
ensuring that the cleaver blade is � ush with
the saw blade.
Retighten the 2 screws.
Replace the bench inlay.

Cleaning and Maintenance

Remove sawdust and dirt using a vacuum
cleaner, or a brush.
Check that the motor ventilation slots are not
blocked.
The saw can be cleaned by wiping its exterior
parts with a damp cloth.
If the carbon brushes are worn down, they
must both be replaced.

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacements parts
• Returns
• Guarantee issues
• Open weekdays from 07.00 to 17.00
(Fridays until 15.00)
• E-mail: [email protected]
GB
31