Technical Details - Pilz PSEN op2/4 Instrucciones De Uso

PSEN op 2/4 Series

9. TECHNICAL DETAILS

Supply voltage:
Current consumption transmitter (TX):
Current consumption receiver (RX):
Outputs:
Output current:
Output voltage ON min.:
Output voltage OFF max.:
Leakage current:
Capacitive load (pure):
Resistive load (pure):
Reaction time:
Transmitter, wavelength:
Resolution:
Operating range:
Category:
Available functions:
Time limits:
Operating temperature:
Storage temperature:
Humidity:
Protection class:
Protection type:
Ambient brightness:
Vibration: Amplitude 0.35 mm, frequency 10 ... 55 Hz, 20 sweeps
Shock resistance:
Reference standards:
Housing material:
Material of upper and lower cover:
Material for optics:
Connections:
Cable runs:
Muting control lamp:
Weight:
* =
The same specifications must be met if a longer cable is used.
** Protection class
Protective earth
Symbol for protective earth
Protection through low voltage power supply (SELV and PELV)
Operating Manual
24 Vdc ± 20% (SELV/PELV)
max. 70 mA / 2.1 W
100 mA max. (excl. load) / 3 W
2 PNP outputs
Short circuit protection 0.68A
max. 0.7 A (total for both outputs)
max. 0.5 A (for a single output)
max. 0.25 A total in the range 45 ... 55°
- 2 V of the operating voltage at T=25 °C
and nominal load of 50mA per channel
0.1 V
< 1 mA
50 nF max at 24 Vdc + 20% [65 nF at 24 V]
56 Ω min. at 24 Vac + 20%
(See table: "Available models")
Infra-red (880 nm)
14 mm finger protection (PSEN op4F)
30 mm limb protection (PSEN op4H)
300...500mm body protection (PSEN op2B/op4B)
0.2...6 m (PSEN op4F), 0.2...15 m (PSEN op4H)
0.5...50 m (PSEN op2B), 0.5...25 m (PSEN op4B)
Type 2 for PSEN op2 / Type 4 for PSEN op4
Total muting/ partial muting/ override
Automatic/manual reset
Muting: 10 minutes / override: 2 minutes
-10...+55 °C
-25...+70 °C
15...95 % (non-condensing)
Class 1 / Class 3 (** see note)
IP65 (EN 60529)
IEC-61496-2
for all axes; 1 octave/min., (EN 60068-2-6)
16 ms (10 G) 1,000 shocks for all axes
(EN 60068-2-29)
EN 61496-1; prEN 61496-2
Varnished aluminium (yellow RAL 1003)
PC MAKROLON
PMMA
4-pin M12 connector on TX
8-pin M12 connector on RX
50 m max. (*see note)
(at 50 nF capacitive load and Vdc = 24 V)
Lamp 24 V 3W min. (125 mA) / 7W max. (300 mA)
1.2 Kg max. / m per unit
Class 1 Class 3
Mandatory Not permitted
Mandatory Not permitted
Recommended Mandatory
42