Lenze L-force 9400 E94ASHE Serie Instrucciones Para El Montaje página 73

DIP switch
Pos. Description
Addressing of the bus node

A
O
N
d
Fig.6-3
For the DIP switches that are placed at the front
the node address (labelling "1" ... "64") and
ƒ
baud rate (labelling "a" ... "d")
ƒ
can be set.

Note!
If all address switches adopt the "OFF" position when the basic device is
switched on, the configurations of codes C00350 (nodes address) and C00351
(baud rate) apply.
Switch the voltage supply of the basic device off and then on again to activate
altered settings.
Setting the node address
The node address of the drive is calculated from the sum of all address switches in the "ON"
position.
Setting the baud rate
d c
OFF ON
OFF ON
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ON ON
OFF ON
OFF ON
Displays
Pos. Colour
MS Green
DE Red
BS Green
BE Red
EDK94SH104 DE/EN/FR/ES/IT 4.1
c b a 64 32 16 8 4 2 1
Baud CAN Address
Arrangement and labelling of the DIP switches
b a Baud rate
ON OFF 10 kbit/s
OFF ON 20 kbit/s
ON ON 50 kbit/s
ON OFF 125 kBit/s
OFF ON 250 kbit/s
OFF OFF 500 kbit/s
ON OFF 800 kbit/s
OFF OFF 1000 kbit/s
ON ON Auto baud
Condition
On
On
Signalling according
to DR303-3

Wiring the device modules
Communication modules
Description
Communication module is supplied with voltage.
Communication module is not accepted by the standard device
(see notes given in the documentation for the standard device).
CANopen state ("Z")
CANopen error ("F")
6
9400CAN003
73