Operating The Safe If Batteries Die - SentrySafe H060ES Manual Del Usuario

Reprogramming the Safe Lock After Override Use
1
2
Using Auxiliary Remote Battery Pack
If the four (4) AA alkaline batteries installed in the door are insufficient to operate the card reader,
keypad, and locking mechanism, the auxiliary remote battery pack (included) can be utilized as a
temporary power source.
1
2
NOTE: • The auxiliary remote battery pack is not a charger – batteries with insufficient strength
must be replaced.
• The master override key can also be used to gain access to the safe.
• Do not use rechargeable batteries or any other type of non-alkaline battery. Do not mix
old and new batteries. Do not mix alkaline and other battery types.

Operating the Safe if Batteries Die

Leave override key in the unlocked position.
Press the "B" button.
The safe lock will beep twice and read "– CARD –".
Close the door and lock it using the override key and remove
the key from the door.
Punch in the code "1234" to open the safe door. The unit has
now been reprogrammed and is ready for use with any four-
digit code or magnetic stripped card.
Install four (4) AA size batteries in the auxiliary remote
battery pack. Note the polarity (+/-) markings in the battery
compartment to ensure proper installation.
Plug the auxiliary remote battery pack on the underside
of the keypad unit.
Plug in the auxiliary remote battery pack to enable temporary
power using your magnetic stripped card or personal code to
unlock the safe.
Replace the 4 AA sized alkaline batteries in the door (as
described on page 5).
10