Manual Release Mechanism - Cardin SL Serie Manual Del Usuario

Fitting the toothed rack
• To fi t the toothed rack to the sliding gate proceed as follows:
- release the geared motor (fi g.11), lay the fi rst stretch of the
toothed rack on the pinion and fi x it to the gate, then fasten down
all the other parts along the entire length of the gate.
- after having fastened the toothed rack, realign the pinion (play of
1 to 2 mm between the toothed runner and the pinion) using the
positioning nuts at the base of the geared motor.
This action will prevent the weight of the sliding gate from dam-
aging the unit when working.
2 mm
8
15 mm
- Once the unit has been correctly
aligned fasten it down using the lock
nuts then position and fasten down
the mechanical travel limits (opening
and closing directions) mounted on
the toothed rack.
• To operate correctly the gate must stop
travel limit activated) about 1cm before it makes contact with
the mechanical closing direction buffer on the upper part of
the gate (pos "E" fi g.1).
INSTRUCTIONS FOR POSITIONING THE UNIT
9
- The geared motor unit has been assembled in the factory to be
fi tted to the left side of the gate (internal view).
To install the motor to the RIGHT of the gate invert the motor
power cables (Red and Black position "CN3" on the electronic
card and the travel limit cables (Red and Blue binding posts "10"
and "11" on the terminal block while the travel limit common wire
(Black position "9") remains in the same position.
1 2 3 4 5 6
10
TD TB TC TA
7 8 9 10 11 12 13 14 15
- Using the "MANUAL MODE" check the correct functioning
of the gate.
(closing direction
CN2
CN3
16 17 18

MANUAL RELEASE MECHANISM

Manual release is normally carried out with the power to the motor
interrupted due to a power failure.
To release the gate use the manual release key supplied with
the unit. The key should be kept inside the house in an easily
accessible place or stored with the unit itself.
11
A
To release the unit
Remove the cover "A" using a screwdriver and insert the key "B"
over the T-shaped pin, then rotate the key through 90 degrees
in the direction indicated by the arrow "C" (clockwise). This will
release the clutch and separate the gears from the motor allowing
you to manually manoeuvre the gate by pushing lightly on it.
To relock the unit
Follow the above instructions in reverse order rotating the key
through 90 degrees in the direction indicated by the arrow "D"
(anticlockwise). Close the release mechanism access cover "A".
Never use the manual release mechanism while the gate is
in operation.
Access to the electronic card
To open the cover insert a screwdriver into the slot "G" and turn
it through 90° as shown in fi g.11
Attention! Before opening the cover make sure that the
power has been switched off at the mains.
16
F
G
9 0 °
C
D
B