Tunturi E4 Manual Del Usuario página 3

W E L C O M E T O T H E W O R L D
O F T U N T U R I E X E R C I S I N G !
Your choice shows that you really want to invest
in your well being and condition; it also shows
you really value high quality and style. With
Tunturi Fitness Equipment, you've chosen a high
quality, safe and motivating product as your
training partner. Whatever your goal in training,
we are certain this is the training equipment
to get you there. You'll fi nd information about
using your exercise equipment and what makes
for effi cient training at Tunturi's website at
W W W.T U N T U R I .C O M .
A S S E M B L Y
Start by unpacking the equipment and check that
you have the following parts:
Frame
1.
Rear support
2 .
Plastic covers for front support
3 .
Handlebar / meter
4 .
Transformer
5.
Assembly kit (contents marked with in the spare
6 .
part list): keep the assembly tools, as you may need
them e.g. for adjusting the equipment.
If necessary, please contact your dealer with the
model, equipment serial no. and spare part no.
of the missing part. You'll fi nd a spare part list at
the back of this guide. The packaging includes a
silicate bag for absorbing moisture during storage
and transportation. Please dispose of the bag once
you have unpacked the equipment. The directions
left, right, front and back are defi ned as seen from
the exercising position.
S UP P ORT S
Place the rear support under the frame and fasten
it with two hex screws and washers. Tilt the cycle
back so that it rests on the rear support and seat.
Push the plastic covers into place at the ends of
the front support. Turn the cycle back to upright
position.
4
H A ND L EBA R
Expose the wire coming from the frame tube
by unwrapping the tape that covers it, and then
connect it to the counterpart in the handlebar
support tube. Ensure that the joint is securely
locked by gently pulling the wire. Thread the wire
carefully inside the frame tube and push the
handlebar support tube into place inside the frame
tube, so that the fastening screws are on the front
of the tube.
(2)
N O T E !
fastening screws through the holes in the tube.
Tighten the fastening screws by turning them
counter-clockwise.
T RAN SF O RME R
Before connecting the equipment to a power
source,make sure that local voltage matches that
indicated on the type plate:the equipment operates
at either 230 V or 115 V (North American
version). Plug the socket of the transformer cord
into the connector just above the rear support, and
the transformer into the wall socket.
Use the enclosed Allen key to tighten both