3M DBI SALA 2104711 Manual Del Usuario página 10

6.0 MAINTENANCE, SERVICING, STORAGE
6.1 cLEANING: Periodically clean the Sliding Beam Anchor's metal components with a soft brush, warm water, and a mild
soap solution. Ensure parts are thoroughly rinsed with clean water.
6.2 WEAr PAd rEmoVAL ANd INSTALLATIoN: The Wear Pads are the only user serviceable component of the
Sliding Beam Anchor. Figure 10 illustrates replacement of the Wear Pads. If inspection reveals cracked or worn pads,
perform the following steps to remove the old pads and install the new replacements pads.
1. Insert a flat head screwdriver between the top of the plastic Wear Pad and the End Clamp.
2.
Slide the screwdriver around to the front of the Wear Pad and pry out the end. Insert the screwdriver between the
bottom of plastic Wear Pad and the End Clamp. Slide the screwdriver around to the front of the Wear Pad and pry out
the end.
3. Pry out the bottom of the Wear Pad and remove it from the End Clamp. Dispose the old Wear Pad.
4. Slide the new Wear Pad in the End Clamp. Apply pressure to snap the new Wear Pad into place.
6.3 SErVIcE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment. If the
Sliding Beam Anchor has been subject to fall force, it must be removed from service immediately, clearly marked "DO
NOT USE", and then destroyed. If inspection reveals an unsafe or defective conditions, remove the system from service
and contact 3M regarding replacement or repair.
6.4 STorAGE ANd TrANSPorT: When not in use, store and transport the Sliding Beam Anchor and associated fall
protection equipment in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may
exist. Thoroughly inspect components after extended storage.
7.0 LABELS
Figure 11 illustrates labels on the Sliding Beam Anchor. Labels must be replaced if they are not fully legible. Information
provided on each label is as follows:
RFID Tag
A
Warning Label:
B
1) Inspect the Sliding Beam Anchor. 2) Do not repair. This product must be serviced by an authorized service center. 3)
Temerature range -40°C - +60°C. 4) Acceptable installation locations and working ranges. Only install on vertical and
horizontal beams with end stops. 5) Store Sliding Beam Anchors in a cool, dry, clean environment; out of direct sunlight.
6) Do not remove the labels from the Sliding Beam Anchor. 7a) Do not use on beams without end stops. 7b) Correct
installation on beams with end stops. 8a) Install on structures rated for 12kN or more. 8b) Do not use on structures
rated less than 12 kN. 9) Do not use on slanted beams.
10) Read the product instructions. 11) Maximum capacity 140 kg (310 lbs). 12) Notified Body ID. 13) Year and month
C
manufactured. 14) Lot number. 15) Model number. 16) Acceptable installation locations and working ranges. Install
on structures rated for 12kN or more. 17) Inspection log. 18) Inspection date. 19) Inspector initials. 20) Sliding Beam
Anchor model number, allowed beam flange widths, and allowed beam flange thicknesses.
10