Step 4 - Mounting The Can Shelf - CPS COLOR COROB D50 Manual Del Usuario

ITEM
35
36
37
Figure 3-2

3.4 Step 4 - Mounting the can shelf

1) Remove the two M4 x 12 Sems screws found in the lower of the Front Panel using a Philips
screwdriver. Do not remove the Front Panel.
2) Insert the Can shelf Pivot Bars (36) x 2 through the holes in the Can shelf (35) (Figure 3-4).
3) Place a Nylon Washer (38) on each end of the two Can shelf Pivot Bars as required.
4) Fit the Nylon Block onto the assembly (37) (Figure 3-4), locating the Pivot Bar in the holes in
the Nylon Block.
5) Holding the assembly together, slide the Nylon Blocks into the slots (Figure 3-4). Once the
Nylon Blocks are fully inside the slots in the Front Panel, the assembly will be held together,
simply raise the shelf until it locks in one of the notches in the Front Panel.
6) Re-insert the two M4 x 12 Sems screws in the lower of the Front Panel using a Philips
screwdriver, which were removed in step 1 above, so that the shelf can not fall out.
ITEM
35
36
37
38
DESCRIPTION
CANISTER ASSEMBLY
THREAD CUTTER SCREW
COVER PANEL
DESCRIPTION
CAN SHELF
CAN SHELF PIVOT BAR
NYLON SLIDE BLOCK
NYLON WASHER
QTY.
1
3
1
Figure 3-3
QTY.
1
2
2
4
9