Step 3 - Mounting Canisters - CPS COLOR COROB D50 Manual Del Usuario

8
ITEM
31
32
12
34
9

3.3 Step 3 - Mounting canisters

1) Remove Cover Panel (37) from packaging, taking care not to cause damage.
2) Place Cover panel on top of unit locating legs of Cover Plate between legs of Agitator Plate.
This must be done before any canisters are mounted!
3) Remove Canister Assembly (35) from packaging.
4) Working at the front of the unit (Figure 3-2), with the Carousel Index Lever locking the
Carousel, locate the Agitation Rod of the Canister (35) into the plastic bushing of the Agitator
Plate, next locate the two screws (36) found in the base of the Canister Assembly in the slots
in the Turntable and turn slowly in an anticlockwise direction.
5) Fasten the two screws (36) x 2 using a 10 mm nut driver or 10 mm spanner or cross-head
screwdriver, depending on screws supplied.
6) Insert a third screw (36) x 1 (Figure 3-3) into the front of the Canister to hold it in place
securely and fasten in as above.
7) Turn the Agitation selector switch to manual (position 1) (chapter 11) to confirm Canister is
agitating as expected, with the paddle inside the canister turning freely.
8) On approval, turn off the Agitation selector switch (position 0) (chapter 11) and unlock the
Carousel Index Lever and rotate clockwise to the next position.
9) Repeat steps 3 to 8 until all the Canisters are assembled on the Carousel.
DESCRIPTION
TURNTABLE
AGITATOR PLATE
TURNTABLE NUT
CRANKSHAFT + NYLON WASHER
BRASS SWIVEL NUT
Figure 3-1
QTY.
1
1
1
1
1
COROB™ D50