Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTRUCTION MANUAL FOR PLASMA CUTTER
IMPORTANT:
BEFORE USING THIS DEVICE, READ
THIS MANUAL CAREFULLY AND MAKE SURE YOU
UNDERSTAND ITS CONTENTS.
IMPORTANT:
Before
instruction manual, read the instructions in General
Warnings manual 3301151 carefully and make sure
you understand them.
Copyright
The copyright of these operating instructions is
owned by the manufacturer. The text and illustrations
correspond to the technical specifications of
the device at the time of printing and are subject
to change. No part of this publication may be
reproduced, stored in a filing system or transmitted
to third parties in any form or by any means, without
the manufacturer's prior written authorisation. We
are always grateful to be informed of any errors and
suggestions for improving the operating instructions.
Always keep this manual at the place where the
device is used.
The equipment can only be used for welding or
cutting operations. Do not use this device to charge
batteries, defrost pipes or start engines.
Only expert staff can install, operate, maintain and
repair this device. An expert staff member means
someone who can judge the work assigned to
them and recognise possible risks based on their
vocational training, knowledge and experience.
Any use that differs from what is expressly indicated
and is implemented in different ways or contrary
to what is indicated in this publication amounts to
improper use. The manufacturer declines any liability
arising from improper use that may cause accidents
to people and possible system malfunctions.
This exclusion of liability is acknowledged upon
commissioning of the system by the user.
The Manufacture is unable to monitor compliance with
these instructions or device installation, operation
and use, and maintenance conditions and methods.
Inappropriate execution of the installation may lead
to material damage and possible personal injury.
Therefore, no liability is assumed for loss, damage
or cost arising out of or in any way connected
with improper installation, incorrect operation or
inappropriate use and maintenance
It is not permitted to connect two or more power
sources in parallel.
If you wish to connect several power sources in
reading
the
following
parallel, ask for written authorisation from CEBORA
which will determine and authorise procedures and
conditions for the required application in compliance
with current product and safety regulations.
Only expert staff can install, operate, maintain and repair
this device. An expert staff member means someone
who can judge the work assigned to them and recognise
possible risks based on their vocational training,
knowledge and experience.
The installation and management of this device/system
must comply with the IEC EN 60974-4 standard.
Liability regarding system operation is expressly
limited to the system's function. Further liability of any
kind is expressly excluded. This exclusion of liability is
acknowledged upon commissioning of the system by the
user.
The Manufacture is unable to monitor compliance with
these instructions or device installation, operation and
use, and maintenance conditions and methods provided
in the 3301151 manual.
Inappropriate execution of the installation may lead to
material damage and consequently to personal injury.
Therefore, no liability is assumed for loss, damage or
cost arising out of or in any way connected with improper
installation, incorrect operation or inappropriate use and
maintenance.
The welding/cutting power source complies with the
regulations set out on the power source technical
data plate.
Use of the welding/cutting power source is permitted
in automatic or semi-automatic systems.
The system installer is responsible for checking the
complete compatibility and correct operation of all
components used in the system.
CEBORA S.p.A. therefore disclaims all liability for
malfunctions/damage to its welding/cutting power
sources and other system components due to the
installer's failure to perform these checks.
15
Tabla de contenido
