Child Requirements; Infant Insert; Changing Harness Position - Nuna pipa Manual Del Usuario

1 To adjust the handle position,
squeeze handle buttons on both
sides and rotate.
2 Rotate handle until it clicks
into any of the 3 positions. Handle
can be used in vehicle in any
locked position.
Be sure handle is locked in the carry
position before lifting carrier by handle.
An unlocked handle could move
unexpectedly, causing injury to child.
Handle MUST NOT contact the vehicle
interior when installed.

Child requirements

1 Weight: 4 to 32 lbs
(2 to 14.5 kg).
2 Height: less than 32 inches
( 81 cm).
3 Top of child's head is at least 1"
below top of carrier.

Infant insert

•
The infant insert can be used as
necessary to provide a snug fit
for smaller babies. The low birth
weight pillow can be used in the
infant insert for even smaller
babies, but should be removed
once unnecessary. The low birth
weight pillow should be removed BEFORE the crotch belt is
moved into another position-at approximately 11lbs.
11
2
1
1in
25
mm
front back
Changing harness
position
Shoulder belts
1 With child placed in car seat, identify harness slots at
or below shoulder level.
2 With child removed, loosen harness. Turn carrier over and
remove one harness loop from metal splitter plate.
3 Pull loose end of harness loop out through slot and place in
correct slot. Re-attach to splitter plate.
12