Nuna pipa Manual Del Usuario página 13

•
If vehicle only has a lap belt, then put lap belt
under blue lockoff.
7 Tighten belt while pressing base into vehicle seat.
8 While the shoulder belt is tight, hook the bottom of blue
lock off and press to close the lock off on the shoulder and
lap belt. Belts must lay flat under lock off.
9 Check the installation.
a) Belts must be tight.
b) Base should not move side to side more than 1" at belt
path
c) Bubble must be touching line.
d) Belts and buckles must not interfere with attachment of
carrier to base.
•
It is acceptable to install with both lATCH (lower attachments)
and the vehicle belt.
10 After child is properly secured in carrier, press carrier on
base and listen for a click. Pull on carrier to verify
proper installation.
Your child may not be
protected in the event of a
crash or sudden stop if you
do not check and verify that
is securely attached.
11 To release the car seat, pull the car seat up
while squeezing the car seat release button.
21
2
CLICK
1
CHECK
2
Stability leg
•
Do not use over vehicle floor storage compartment.
•
Do not use if stability leg lifts base off seat.
Do not use stability leg to
recline the base. The recline
adjustment feature is meant
to recline the base.
•
Always store stability leg when not
in use.
1 Unfold the stability leg from storage compartment.
2 After correctly installing the base on the
vehicle seat, extend the stability leg to floor.
•
Stability leg must be vertical.
•
The stability leg has 12 positions.
When the stability leg indicator shows red
this means the stability leg is in the wrong
position. Make sure the stability leg is secure
by pressing down on the front of the base.
The stability leg indicator shows green when
it is vertical and properly contacting the floor
of the vehicle.
1
1
2
22