Página 1
BASE PARA DUCHAS BASE PARA DUCHAS / REGADERAS Model / Modelo / Modéle 36” 40054 Write purchased model number here. Retain these instructions for future use. Escriba aquí el número del modelo comprado. Conserve estas instrucciones para usarlas en el futuro.
REQUIREMENTS FOR SUCCESSFUL INSTALLATION KNOWLEDGE BASE: Framing Plumbing These instructions include suggestions for rough construction and plumbing installation. Local building codes vary and could supersede those suggestions. If you are not confident in your ability to perform these tasks, contract out those tasks you need help with or use a professional installer. DO NOT use drywall screws to secure flanges to wall studs.
TOOLS AND MATERIALS REQUIRED • 2 x 4 lumber for additional wall studs • Rags or padding to protect product during bracing NOTE: It is recommended to install insulation. HERRAMIENTAS Y MATERIALES NECESARIOS • Madera para montantes de pared si instala el juego para pared adicionales; consulte las instrucciones de instalación del juego para pared •...
Página 4
ROUGHING-IN • Rough plumbing must be installed before panel installation. • Minimum stud pocket sizes are shown below. • Drain cutout 5” diameter max. Right side plumbing rough-in shown. • For masonry construction, floor and walls must be framed to accommodate plumbing and installation. IMPORTANT: IF INSTALLING MATCHING WALL SET, refer to Wall Set Installation Manual for specific lumber sizes and placement.
Página 5
5" (12,7cm) 1-3/4" (4,45cm) Install Drain Pipe Dry fit base and verify that it is straight and square. Trace outline of drain and base. Ensure that the waste pipe is properly located to align with the drain assembly (not included). The subfloor opening should be 5”...
Página 6
REQUIRED FOR PROPER INSTALLATION IF THE SUBFLOOR IS NOT FLAT AND LEVEL Entire bottom support must be in contact with a flat level surface as shown. If installation surface is not level, a mortar bed must be applied where the base will be positioned. REFER TO STEP 5 FOR INSTRUCTIONS.
Página 7
3/16" 3/16" (0,51cm) (0,51cm) Drill 3/16” holes at all stud locations on top flanges. Attach drain following manufacturer’s instructions. Drill 3/16” clearance holes into flanges only. Do not drill 3/16” Plumber’s putty will degrade base material. Do not use plumber’s holes directly into studs.
Página 8
Shim Shim IF THE SUBFLOOR IS NOT FLAT IF THE SUBFLOOR IS FLAT AND 1-1/4" 1-1/4" AND LEVEL, a mortar bed must LEVEL, apply adhesive on floor be applied where the base will be and spread using the notched (3,17cm) (3,17cm) positioned.
CARE AND CLEANING For regular cleaning use ONLY mild detergents or warm, soapy water. Use ONLY non-abrasive cloth or sponge. Always rinse surfaces after cleaning. Before cleaning this product with cleaning products, test a small, inconspicuous area. Manufacturer does not recommend the use of cleaning products that contain any of the following chemicals.
WILL VOID THE WARRANTY. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. It applies only to Delta® Shower Base units installed in the United States of America, Canada and Mexico.