Operations; Button Operation - PowerWalker 1000 LCD Manual De Instrucciones

3. Operations

3-1. Button operation

Button Function
 Turn on the UPS: Press and hold ON/Mute button for at least 2
 Mute the alarm: When the UPS is on battery mode, press and hold
ON/Mute Button
 Up key: Press this button to display previous selection in UPS setting
 Switch to UPS self-test mode: Press ON/Mute buttons simultaneously
 Turn off the UPS: Press and hold this button at least 2 seconds to turn
OFF/Enter Button
 Confirm selection key: Press this button to confirm selection in UPS
 Switch LCD message: Press this button to change the LCD message
Select Button
 Setting mode: Press and hold this button for 3 seconds to enter UPS
 Down key: Press this button to display next selection in UPS setting
 Switch to bypass mode: When the main power is normal, press
ON/Mute + Select
Button  Exit setting mode or return to the upper menu: When working in
seconds to turn on the UPS.
this button for at least 3 seconds to disable or enable the alarm
system. But it's not applied to the situations when warnings or errors
occur.
mode.
for 3 seconds to enter UPS self-testing while in AC mode, ECO mode,
or converter mode.
off the UPS in battery mode. UPS will be in standby mode under
power normal or transfer to Bypass mode if the Bypass enable setting
by pressing this button.
setting mode.
for input voltage, input frequency, battery voltage, output voltage
and output frequency. It will return back to default display when
pausing for 10 seconds.
setting mode when UPS is in standby mode or bypass mode.
mode.
ON/Mute and Select buttons simultaneously for 3 seconds. Then UPS
will enter to bypass mode. This action will be ineffective when the
input voltage is out of acceptable range.
setting mode, press ON/Mute and Select buttons simultaneously for
0.2 seconds to return to the upper menu. If it's already in top menu,
press these two buttons at the same time to exit the setting mode.
7
EN