Idiomas disponibles
Idiomas disponibles
Install
Battery
Unscrew the Electronic
Igniter Cap. Install Battery into the Igniter with the positive
(+) end out. Screw
the cap back into place.
From the inside of the cabinet,
feed the power cord for the Grill
Lights through
the hole in the left
cabinet
side.
Battery
(Size AA)
Qty: 1
Place and Secure
LP Cylinder
into the Cabine
Rotate the LP Cylinder
Tray Latch on the left front corner of the tray counterclockwise
to release the
tray lock.
Slide the tray out of the cabinet
by pulling
on the Tray Handle (Inset 1).
Unscrew the Wing
Bolt on the back of the LP Cylinder
Tray (Inset 2). Place a leak-tested
LP Cylinder
into the tray. Make sure the cylinder
valve faces the right side of the cabinet.
Secure the LP Cylinder
into the tray by tightening
the Wing
Bolt on the back of the tray.
Slide the LP Cylinder
Tray back into the cabinet
and lock in place by rotating
the LP Cylinder
Tray
Latch clockwise
(Inset 3).
Be sure the LP Cylinder
Valve is OFF by turning
the hand wheel clockwise
until it stops. Ensure all Burner
Control
Knobs are in the OFF position.
Remove the safety cap from the LP Cylinder
Valve. Center the
nipple
of the Regulator
into the Cylinder
Valve and attach
to the tank by turning
the black nut
clockwise
until it stops (Inset 4).
Note: Hand tighten
only.
Do not use a wrench.
Do not attempt
to light your grill at this time.
Inset 1
Inset 2
Inset 3
Inset 4
24
