CAME CHOPIN Manual Del Usuario página 10

quicker and the lights keeps getting brighter
and then stays lit permanently when the set
limit exceeded.
When the brightness drops beyond the limit
for at least 15' , the control unit commands a
closing cycle and exits the alarm mode.
If the light brightness drops rapidly, in a
3-minute span, below the 15 Klux, the control
unit commands a closing cycle and shift out
of alarm status.
O
R ENABLING OR DISABLING THE SUN SENSOR
The procedure must be performed with the
awning completely retracted. wait at least 4'
before performing the sequence.
Press 10 times the up Button (↑).
The motor performs a click-clack movement.
Within 10" press:
→
Enable UP x 10 times click clack + UP x 2
→
Disable UP x 10 times click clack + UP x 3
CONTROL UNIT TEST MODE AND RESETTING
RESET: By pressing the RESET button the
control unit zeros out any alarms underway;
the LED-light will flash for 3".
TEST: By keeping pressed the rest button
for 10", the control unit goes into test mode
and the LED-light stays lit permanently. In
this phase, which lasts 5' , all alarm times
are reduced to 30". Once the 5 minutes have
elapsed or once the reset button is pressed, the
control unit returns to normal working mode,
and the LED-light switches off.
P
WIND ON SHUTTERS
If an anemometer is fitted to shutters, enable
the "wind on shutters" setting. Once the
threshold is breaqched, it activates the lowering
(and not the raising as in the awning), inhibiting
119T70509 - ver. 1.0 - 03/2012
the commands. A lacking "life status" signal
does not trigger any movement.
The procedure must be performed with the
awning completely retracted. wait at least 4'
before performing the sequence.
Press the DOWN button 10 times (↓) . The
motor performs a click-clack movement.
Within 10" press:
→
Enable UP x 10 times click clack + UP x 2
→
Disable UP x 10 times click clack + UP x 3
DECLARATION - Came Cancelli Automatici
S.p.A. declares that this device is compliant with the
essential requirements and other pertinent measures
established by directive 2006/95/CE, 2004/108/CE
For any malfunctioning problems, please contact:
[email protected]
Dismantling and disposal - Before proceeding it is
always a good idea to check your local legislation on
the matter.
Other components (i.e. electronic cards, transmitter
batteries, etc.) may contain hazardous substances.
These must therefore be handed over the specially
authorised disposal firms.
DO NOT DISPOSE OF IN NATURE!
The data and information in this manual may be changed at
any time and without prior notice.
119T70509 - ver. 1.0 - 03/2012