Setting The Clock (Remote Control Only) - Sharp XL-BB20D Manual De Manejo

Setting the clock (Remote control only)

In this example, the clock is set for the 24-hour (0:00 - 23:59)
display.
1
Press the (ON/STANDBY) button to turn the power
on.
2
Press the CLOCK button.
3
Within 10 seconds, press the ENTER button. To adjust
the day, press the
press the ENTER button.
4
Press the or
12-hour display and then press the ENTER button.
The 24-hour display will appear.
(0:00 - 23:59)
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
or button and then
button to select 24-hour or
EN-8
5
To adjust the hour, press the
and then press the ENTER button. Press the
button once to advance the time by 1 hour. Hold
it down to advance continuously.
6
To adjust the minutes, press the
ton and then press the ENTER button. Press the
or button once to advance the time by 1 minute.
Hold it down to advance the time by 5 minutes interval.
To confirm the time display:
Press the CLOCK button. The time display will appear for
about 10 seconds.
Note:
When power supply is restored after unit is plugged in again
or after a power failure, reset the clock.
To readjust the clock:
Perform "Setting the clock" from step 1.
To change the 24-hour or 12-hour display:
1
Clear all the programmed contents. [Refer to "Factory
reset, clearing all memory" on page 21 for details.]
2
Perform "Setting the clock" from step 1 onwards.
or button
or
or but-