Radio Control For Mod. Night One Day Radio And Night One Day Radio Auto - FAAC Night ONE Day Manual De Instrucciones

11.4 Radio control for mod. NIGHT ONE DAY RADIO and NIGHT ONE DAY RADIO AUTO

On the remote control, every single pressure on the open or close key commands a complete movement.
To stop a manoeuvre, press the STOP push-button otherwise the motor will continue operating until time-out
ends (approx. 16-18 sec.).
11.4.1 MeMORY-STORAGe OF THe FIRST ReMOTe cONTROl ON THe ReceIVeR
A A
B B
A A
B B
At the end of the memorisation procedure, if the
movement of the shutters does not correspond
to the remote control key
- delete the remote control (as described in
section 11.4.3)
- repeat the programming procedure by pressing
the key (OPeN or clOSe) opposite to that used
before.
A
OPeN
STOP
clOSe
B
B B
A A
B B
A A
Fig. 38
PROGRAMMING
IN THe ReceIVeR INSIDe THe MOTOR YOU cAN
M e M O R Y S T O R e M A X : 2 0 RA D I O D e V I c e S
( W A l l - F I T T e D R e M O T e c O N T R O l S , RA D I O
ANeMOMeTeRS; eTc.). MeMORISATION OccURS IN
ANY MOTOR cONDITION.
According to the type of configuration of your installation (Fig.
) follow the instructions given in the following paragraphs.
1) Supply the motor with power.
2) Within 15 seconds press the programming P key
and then the OPEN key of the transmitter.
3) The motor will perform two brief movements in
both direction to confirm correct programming.
4) Perform some brief opening, stop and closing
movements to check the correct operation.
1) Supply the motor with power.
2) Within 15 seconds press the programming P key
and then the CLOSE key of the transmitter.
3) The motor will perform two brief movements
in both directions to confirm correct program-
ming.
4) Perform some brief opening, stop and closing
movements to check the correct operation

P
keY
Fig.37
TYPe A
TYPe B