FAAC Night ONE Day Manual De Instrucciones página 43

6.4 Securing holes
1) Assemble the pieces and position them under the lintel or as a support (the figure shows installation on
the lintel).
2) Mark the position of the frame holes with an adequate bit.
3) Place the expansion plugs in the holes
ATTENTION: Quality of securing is essential for a correct
operation of the device.
6.5 Securing the frame
1) Make sure that the frames are aligned.
2) With the spirit level, check if the device is horizontal.
3) Add the supplied toothed washers and tighten the tie-rods with a No. 13 spanner.
4) Go to chapter 9
Fig. 15

Fig. 16