Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Recessed mount installation
Unit: inch (mm)
6-11/16" (170)
13/32" (10)
post
Wall
Screw (4×30)
post
Resin cover
1) Cut out the wall using the dimensions in the left figure.
2) Remove the 4 screws, and remove the metal cover and the resin cover.
Note: This procedure is the same as the wall surface mount installation.
3) Connect the equipment lead wires to the controller board. (Refer to "4-2.
Wiring")
4) Use the accessory fasteners to affix the connected lead wires. Use the
mounting cord clamp to affix the power supply cable.
Note: Refer to the figure in the procedure of the wall surface mount
installation for the routing layout of the lead wires.
5) Use the 3 screws to install the Equipment Controller to the post. Make sure
to use each screws
Notes:
● Do not damage the controller board's lead wires when affixing the screws.
● When installing on a post, the level difference between the wall surface
and the Equipment Controller's cover must be 1/32" (1) or less.
6) Attach the resin cover, and affix the panel for recessed mounting
the 4 screws.
Screw(4×30)
, Spring washer
, Flat washer
Panel for recessed
mounting
with 1 spring washer
and 1 flat washer
Screw: 4 pieces
.
with
EN-8
Capítulos
Tabla de contenido
