Dismantling The Canopy; Cleaning And Maintenance; Storing The Canopy; Repairing A Puncture In The Air Pole - Dometic Club AIR Pro Instrucciones De Montaje

Set up the canopy as follows:
1. To protect the canopy from dirt and damage,
cover the setup location with a groundsheet
or footprint.
2. Unpack the canopy.
3. Separate and identify the different
components.
4. Proceed as shown to set up the canopy
(fig. 1, page 3 to fig. 5, page 5).

Dismantling the canopy

A
NOTICE! Material damage
Do not use force when dismantling the
canopy. Otherwise you might damage
material.
1. Remove any dirt.
2. Remove all pegs.
3. Remove all lines and straps.
4. Open the valves on each pole.
5. Wait until most of the air has been expelled.
6. Unzip the canopy from the awning tent.
7. Fold/roll the canopy towards the valves to
expel more air.
8. When deflated, roll the canopy to fit into the
carry bag.
9. Ensure that all parts are clean before packing
them into the carry bag.
10. If the canopy is wet or damp, dry fully as soon
as possible.

Cleaning and maintenance

A
NOTICE! Material damage
• Do not use sharp or hard objects or
cleaning agents for cleaning.
• Do not use alcohol based materials,
chemicals, soap and detergents for
cleaning.
• Remove bird droppings and tree resin
as soon as possible to avoid perma-
nent damage to the material.
1. If necessary, clean the product with clean
water and a soft brush.
8
2. Apply impregnation against water and UV
radiation before each trip.

Storing the canopy

I
NOTE
• Fully set up the canopy for cleaning.
• Choose a sunny day for cleaning to
1. Clean the canopy.
2. Air fully and ensure the canopy is totally dry
before packing away.
3. Store in a well ventilated dry place.

Repairing a puncture in the air pole

If the air pole loses air, proceed as follows:
1. Unzip the outer sleeve holding the air pole.
2. If installed, close isolation valves.
3. Remove the air pole.
4. Deflate the air pole.
5. Unzip the protective sleeve to expose the
inflatable tube.
6. Blow some air into the inflatable tube.
7. Submerge the tube in water.
8. Locate the puncture.
9. Use repair tape and repair solution to seal the
hole.
10. Zip the inflatable tube back into the protective
sleeve.
11. Zip the air pole back into the outer sleeve.
Disposal
➤Place the packaging material in the appropriate
recycling waste bins, wherever possible.
M
If you wish to finally dispose of the product,
ask your local recycling center or specialist
dealer for details about how to do this in
accordance with the applicable disposal
regulations.
4445103329
ensure the material will dry thoroughly.