Refrigerant Piping - MAXA 2600 W Manual Usuario

 If possible, do not install the unit where it is exposed to direct sunlight. If necessary, install a blind that does not interfere
with the air flow.
 During the heating mode, the water drained off the outdoor unit. The condensate should be well drained away by the drain
hole to an appropriate place, so as not to interfere other people.
 Select the position where it will not be subject to snow drifts, accumulation of leaves or other seasonal debris. If
unavoidable, please cover it with a shelter.
 Locate the outdoor unit as close to the indoor unit as possible.
 If possible, please remove the obstacles nearby to prevent the performance from being impeded by too little of air
circulation. (see figure below)
Side air outlet outdoor unit
■ Install the drain joint of the outdoor unit
Fit the seal into the drain joint, and then insert the drain joint into the base pan hole of outdoor, rotate 90° to securely
assemble them. Connect the drain joint with an extension drain hose (Locally purchased), in case of the condensate
draining off the outdoor unit during the heating mode. (See figure below)

5.7.2. Refrigerant piping

1) Flaring
■ Cut a pipe with a pipe cutter.
O
(Wall or obstacle)
Ai r inlet
>30cm
N
Ai r inlet
m
c
0
0
M
2
>
The ba se p an ho le
S eal Dra in joint
o f ou td oor u nit
Drai n
The b ase pan
of outdo or un it
Oblique Roughness Burr
90°
X
m
c
0
3
>
Maintain channel
>60cm
P
Air outlet
Sea l
join t
A
34