Part Names And Their Functions Of The Indoor Unit - MAXA 2600 W Manual Usuario

2. PART NAMES AND THEIR FUNCTIONS OF THE INDOOR UNIT

!
CAUTION
Before opening the front panel, be sure to stop the operation and turn the breaker OFF.
Do not touch the metal parts on the inside of the indoor unit, as it may result in injury.
 Titanium Apatite Photocatalytic Air-Purifying Filter:
♦ These filters are attached to the inside of the air filters.

Air outlet

Display

Front panel

Louvers (vertical blades)
♦ The louvers are inside of the air outlet.
 Air inlet

Air filter

Flap (horizontal blade)

Air outlet selection switch

Room temperature sensor
♦ It senses the air temperature around the unit.
Liquid – gas connections
DISPLAY
 Cool mode lamp

Heat mode lamp

Dry mode lamp

Run lamp

LED display

.Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a short beep.
• Settings changed beep

Indoor Unit ON/OFF switch:
• Push this switch once to start / stop operation.
• The operation mode refers to the following table.
Mode Temperature setting
AUTO
• This switch is useful when the remoter is missing.
Air flow rate
25°C AUTO
2 3 6
1
8
7
4
2
5
11
Air outlet selection switch
This setting blows air from upper outlet only.
This setting automatically decides a blow pattern
depending on mode and conditions.
• This setting is recommended.
• The unit is shipped from the factory with this setting.
DISPLAY
1
2
7
9
10
3
4
5
6
26