MAXA 2600 W Manual Usuario página 29

● Filters
1. Open the front panel.
2. Remove the air filter.
• Press the claws on the right and left of the air filter down slightly, then pull
upward.
3. Take off the Titanium Apatite Photocatalytic Air-Purifying Filter.
• Hold the tabs of the frame, and remove the claws in 4 places.
4. Clean or replace each filter.
See figure.
5. Set the air filter and Titanium Apatite Photocatalytic Air-Purifying Filter as
they were and close the front panel.
• Operation without air filters may result in troubles as dust will accumulate
inside the indoor unit.
● Clean the air filter
Vacuum cleaner or pure water may be used to clean the air filter. If the dust
accumulation is too heavy, please use soft brush and mild detergent to
clean it and dry out in cool place.
The air-in side should face up when using vacuum cleaner.
The air-in side should face down when using water.
● Titanium Apatite Photocatalytic Air-Purifying Filter
The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed by washing it with water once every 6 months. We
recommend replacing it once every 3 years.
● Maintenance
1. Vacuum dusts, and soak in warm water or water for about 10 to 15 minutes if dirt is heavy.
2. Do not remove filter from frame when washing with water
3. After washing, shake off remaining water and dry in the shade.
4. Since the material is made out of paper, do not wring out the filter when removing water from it.
● Replacement
1. Remove the tabs on the filter frame and replace with a new filter.
• Dispose of the old filter as flammable waste.
• Dispose of the old filter as flammable waste.
28