Electrical Connections - entrematic Ditec PWR50H Manual Tecnico

6.7. Electrical connections

The PWR50H/HR/HV gearmotors can be connected to the LCU40H control panels.
To connect the automation to the control panel, proceed as follows:
• Remove the rear cover [7] as explained in paragraph 6.4.
• Fit the cable gland on the automation, inserting it in the relative threaded hole in the metal
fusion (Fig. 6.2 and 6.3).
• Connect the various wires as shown in the electrical diagram in Fig. 6.4.
• Fasten the rear cover [7] to the gearmotor.
The electrical connections and start-up of the PWR50H/HR/HV gearmotors are explained in the
installation manuals of the LCU40H control panels.
To increase the protection of the motor cable, a corrugated flexible tube can be used.
Motoriduttore 24V con
24V gearmotor = with
ritardo in apertura
opening delay
33/36 32/35 31/34
M2
Control panel
Quadro elettronico
Alimentazione
Power supply
~
230V
230V ~ - 50/60 Hz
Fig. 6.2
Motoriduttore 24V
24V gearmotor = with
ritardo in chiusura
closure delay
33/36 32/35 31/34
M1
L N 36 35 34 33 32 31
24V
- 50/60 Hz
con
M2
24V
34
Fig. 6.3
Fig. 6.4
M1