3M DBI SALA Smart Lock 3503800 Manual Del Usuario página 17

and conditions, it may be necessary to restrain the free end of the tag line to prevent interference and entanglement with
equipment or machinery.
5.0 Inspection
5.1 RFID TAG: The Self-Retracting Device includes a Radio Frequency Identification (RFID) tag (see Figure 12). The RFID
tag can be used with the handheld reading device and web based portal to simplify inspection and inventory control and
provide records for your fall protection equipment. For details, contact a 3M Customer Service representative (see back
cover). Follow the instructions provided with your handheld reader, or on the web portal, to transfer your data to your
web log.
5.2 INSPECTION FREQUENCY: The Smart Lock Self-Retracting Device must be inspected at the intervals defined in "Section
2.2 - Inspection Frequency". Inspection procedures are described in the "Inspection & Maintenance Log" (Table 3).
;
Extreme working conditions (harsh environments, prolonged use, etc.) may require increasing the frequency of
inspections.
5.3 UNSAFE OR DEFECTIVE CONDITIONS: If inspection reveals an unsafe defective condition, remove the
Self-Retracting Device from service immediately, mark as "UNUSABLE", and send to an authorized service center for
repair.
;
Only 3M or parties authorized in writing may make repairs to this equipment.
5.4 PRODUCT LIFE: The functional life of 3M Self-Retracting Devices is determined by work conditions and maintenance. As
long as the product passes inspection criteria, it may remain in service.
6.0 MAINTENANCE, SERVICE, and STORAGE
6.1 CLEANING: Cleaning procedures for the Self-Retracting Device are as follows:
• Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRD so excess water can
drain out. Clean labels as required.
• Clean lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with heat. An
excessive buildup of dirt, paint, etc. may prevent the lifeline from fully retracting back into the housing causing a
potential free fall hazard. Replace lifeline if excessive buildup is present.
6.2 SERVICE: Additional maintenance and servicing procedures must be completed by an authorized service center. Do not
attempt to disassemble the SRL or lubricate any parts.
6.3 STORAGE AND TRANSPORT: Store and transport Self-Retracting Device in a cool, dry, clean environment out of direct
sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the SRL after any period of extended storage.
7.0 Labels
Figure 18 illustrates labels on the the Smart Lock Self-Retracting Devices and their locations. All labels must be present on the
SRD. Labels must be replaced if they are not fully legible. Pictograms on the labels are defined as follows:
1 Read Use Instructions located under the Lifeline Bumper
2 Do not load SRD Casing over an edge.
3 1 Person Capacity (See other side of label for weight range)
4 SRL - Not Leading Edge - Do not use over an edge.
5 SRL-LE - Leading Edge - Can be used over an edge.
17