Initial Setup; Adjustment Options; Additional Functions; Maintenance And Care - swissflex uni 08 75K Modo De Empleo

CAUTION! The uni 08_75K and ac-
cessories must be protected from
rain and other moisture to prevent
causing a fire hazard or the risk
of electric shock. When instal-
ling the slat base, ensure that the
head, back and foot sections are
not obstructed by furniture.
Ensure that the mains supply is
disconnected before any assem-
bly or disassembly work is carried
out on the slat base or the bed
frame.
Handle the uni 08_75K and ac-
cessories with care; do not disas-
semble or modify them, do not
allow children to play with them
and prevent frail individuals from
using the product without super-
vision.
The product may not be used with
a medical device or be installed in
a medical device.
The product may not be used in an
environment in which flammable
or explosive gases or vapours (e.g.
anaesthetics) are likely to occur.
The product may not be used to
raise and lower loads. Only use
spare parts that have been produ-
ced or a proved by Swissflex. Only
these parts guarantee adequate
safety.
EN

Initial setup

Connect the cable remote control to the motor housing
(7) of the uni 08_75K.
Connect the power supply unit with integrated mains
isolation (8) from the uni 08_75K motor housing to a
power outlet.

Adjustment options

To preset your sleep position, the head piece can be
manually locked in one of four positions. The setting
of the back section has virtually no impact on the end
position of the head piece.
The remaining comfort zones can be adjusted indivi-
dually via the single function buttons (1 – 4) or jointly
via the combined button (5+6).
Resetting all comfort zones to the horizontal posi-
tion
Press and hold the button (6), until all comfort zones
have reached the horizontal position and the motors
have stopped. In case of a power failure, the basic
position can only be reached through the emergency
set-down function.

Additional functions

Controlling a second slat base
A second slat base can be controlled individually or
jointly through parallel controls. The parallel cont-
rols are available as an optional accessory from your
Swissflex stockist.
Connecting the parallel controls
Connect the cable remote control to the relevant con-
nector at the parallel controls and connect both ends
with the motors (7).

Maintenance and care

Do not store or use the uni 08_75K and accessories in
extreme temperatures in excess of 60°C, as this can
lead to malfunctions and deformation of parts. The uni
08_75K has been designed for use in temperatures
between + 5 °C and 40 °C.
Disconnect the mains cable (8) from the power outlet,
before installing or removing a slat base. Do not feed
cables through the adjustment mechanism to prevent
Operating instructions
11