ResMed AirStart10 APAP Guia Del Usuario página 10

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

 
Checking
You should regularly check the water tub, air tubing and the air filter for any damage.
1. Check the water tub:
 Replace it if it is leaking or has become cracked, cloudy or pitted.
 Replace it if the seal is cracked or torn.
 Remove any white powder deposits using a solution of one part household vinegar to
10 parts water.
2. Check the air tubing and replace it if there are any holes, tears or cracks.
3. Check the air filter and replace it at least every six months. Replace it more often if there are any
holes or blockages by dirt or dust.
To replace the air filter:
1. Open the air filter cover and remove the old air filter.
The air filter is not washable or reusable.
2. Place a new air filter onto the air filter cover and then close it.
Make sure the air filter is fitted at all times to prevent water and dust from entering the device.
Reassembling
When the water tub and air tubing are dry, you can reassemble the parts.
1. Connect the air tubing firmly to the air outlet located on the rear of the device.
2. Open the water tub and fill it with distilled room temperature water up to the maximum water
level mark.
3. Close the water tub and insert it into the side of the device.
4. Connect the free end of the air tubing firmly onto the assembled mask.
Therapy data
Your AirStart 10 device records your therapy data for you and your care provider so they can view
and make changes to your therapy if required.
SD card
Your therapy data is stored the SD card. Your care provider may ask you to send the SD card by mail
or to bring it in. When instructed by your care provider, remove the SD card.
Do not remove the SD card from the device when the SD light is flashing.
8
Tabla de contenido
loading

Este manual también es adecuado para:

Airstart10 cpap

Tabla de contenido